Hama 00012084 Bedienungsanleitung Seite 11

• To stop searching, press SHIFT (16) and
then EXIT (13).
• Briefly press the Shift (16) key.
When the remote control instead of 1 only
every 3 seconds a new code is supposed to
send, you go on as follows.
You press within 6 seconds according
to pressures of the key P+ (14) (and/or
POWER (17)) how in before described, the
key P+ (14) or
P- (14) still once. The remote control sends
now a new code only every 3 seconds.
Through that you win more time in order to
abort the process, however, the code search
through that lasts also longer.
Code-identification
The code identification offers you the
possibility, already to determine entered
codes that are stored in the remote control.
So go ahead.
• Hold the key setup (4) pressed for approx.
3 seconds until the red LED (1) lights up
permanently.
• Press the source key (3) (TV, STB, CBL,
AUDIO, AUX, VCR, CD, DVD) shortly.
! Press the „Mode" (2) button before using
the group of devices (AUX, AMP, DVB-T,
CBL).
• You press the key setup (4) shortly, the
red LED (1) goes out shortly during the
keystroke.
• In order to find the first number, you press
the numeric keys (8) from 0 to 9.
• If the red LED (1) goes out shortly, it is the
first
stored number.
• In order to find the second number, you
press in turn the numeric keys (8) from 0
to 9 until the red LED (1) goes out.
• Repeat the process for the third and the
fourth number.
8
• The red LED (1) goes out as soon as the
key was pressed for the fourth number.
• The code-identification is now finished.
Normal use
After you have carried out the programming
of your remote control for yours audio/video
device, the remote control works in the most
common primary functions as the original
remote control of the respective device.
Focus your remote control on the wanted
device and press the corresponding source
key. The red LED will light up shortly.
They activate the functions now through
pressing of the corresponding function key of
your universal remote control.
At every keystroke the red LED lights up
shortly.
Possibly every function of your original
remote control is not directly available on the
universal remote control.
In particular near newer devices it is possible
that the functions are first of all put aside or
not at all available among other keys than
expected.
With the AV Taste you choose usually the
AV input of the TV set for e.g. the STB
receiver or the video recorder.
Special functions
„electronic program"
The key EPG (12) corresponds to the function
„Electronic Program Guide" and has different
functions, depending on which device this
is used.
At STB - or VCR - codes keep you up the key
a programming carry out, provided that
your video recorder about a SHOWVIEW
- function.