Inhaltsverzeichnis
Werbung
INSTRUCTIONS MANUAL
Thank you for choosing our product. This instructions manual has
been prepared for you to achieve complete satisfaction and maximum
performance from your product READ THESE INSTRUCTIONS CARE-
FULLY BEFORE USING THE APPLIANCE AND KEEP THEM FOR FUTURE
REFERENCE.
CONTENTS
I. IMPORTANT SAFETY & USAGE INSTRUCTIONS
II. GENERAL DESCRIPTION
III. TECHNICAL FEATURES
IV. PREPARING FOR USE
V. USING THE APPLIANCE
VI. CLEANING & MAINTENANCE
I. IMPORTANT SAFETY & USAGE INSTRUCTIONS
• Check if the voltage indicated on the type plate sticker located under
the wheel group corresponds to the local mains voltage before you
connect the appliance.
• The appliance should only be connected to power outlets which are
suitably with minimum 10 Amp fuse.
• Do not insert the mains plug into the wall socket until the appliance
is completely ready for use.
• Always remove the mains plug from the wall socket if the appliance
doesn't operate.
• This appliance can be used by children aged from 8 years and above
and persons with reduces physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and
understand the hazard involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without
supervision.
• Unit shouldn't be used if the cord or plug is damaged, if any defects
are present, if you have dropped the unit or have broken any of its
parts. In such cases, you must take it to a certified service center to
be checked, repaired or adjusted.
• Do not allow the appliance to pass over the cable as this may damage
the insulating shield.
• Keep the appliance and the cleaning liquid out of reach of children
• Never use appliance without the foam filter
• Never immerse the motor unit in water
• Never spray the shampoo at plugs, sockets or electrical appliance
• Do not attempt to use the appliance if it appears to be defective.
• Always switch the appliance off after use and remove the mains plug
from the wall socket.
• Always empty, clean and dry container after wet use. Let the appliance
suck in dry air for few minutes to dry the inside of the tubes and hose.
This prevents unpleasent smell.
• Do not point the hose at the eyes or ears nor put it in your mouth when
the appliance is switched on.
• Take particular care when cleaning stairs.
• Switch off immediately in the event of leaking liquid.
• Use only original accessories and spare parts to ensure the perfect
performance of your cleaner and to benefit from the guarantee.
• For repairs or spare parts, contact your local service agents.
• Do not operate the pump while shampoo reservoir is empty or it is
not needed to inject water or shampoo. If pump works without water,
pump temparature in increased and control part cuts off the pump
operation. Pump doesn't work in 30 minutes before cooling.
• Always use the shampoo which is advised by manufacturer.
• Make sure that all textiles and surfaces to be cleaned are suitable for
shampooing. Especially for delicate, hand woven carpets test a small
area first and wait for checking the result..
WARNING : Never use the appliance to clean up flammable or ex-
plosive solvents, object soaked with such solvents, explosive dusts,
liquids such as petrol, oil, alcohol, thinners and objects that are hotter
than 60oC, as this will cause a serious explosion and fire hazard! The
appliance must not be used near flammable substances and must
not be used to clean up health endangering dust.
II. GENERAL DESCRIPTION
Main parts of the appliance are shown as follows (Figure 1)
A. MOTOR UNIT
This group contains motor, pump, switch and operating units on. Top of
this group, there is a HEPA FILTER which filters dust and other particles
from blowing air. If you remove the foam filter, you will see a large plastic
float in a case. As the container fills, this plastic float rises up and cuts
off the vacuum action to warn you when the container needs emptying.
A1 - Pump switch
A2 - On/Off switch
A3 - Shampoo hose connector A7 - Float group
A4 - Hepa filter housing
B. CONTAINER GROUP
Container Group is the middle part of the cleaner for collecting dust
and dirty water. This group is fastened with Motor Unit using clip locks.
Shampoo reservoir which contains shampoo and clean water is placed
under the container group.
B1 - Container
B2 - Water filter body
B3 - Sponge for water filter B7 - Locking nest
B4 - Water filter tube
C. SHAMPOO RESERVOIR GROUP
Shampoo reservoir contains shampoo and clean water. When pump
is operated, shampoo and water is extracted from the shampoo reservoir.
Coming water from tank through water tube is sprayed. Shampoo reservoir
is located between container and wheel group.
C1 - Shampoo reservoir
C2 - Short shampoo hose
C3 - Shampoo hose connection adapter
C4 - Water level indicator
D. WHEEL GROUP
D1 - Wheel chassis
D2 - Wheel
D3 - Locking peg
E. HOSE GROUP
This group contains suction hose with hand grip, shampoo hose group and
suction tubes. Suction hose is connected to container group by inserting the
suction hose into the suction inlet. Suction tubes are connected to hand
grip if necessary. Handgrip contains a mechanical sliding for regulating
suction power and shampoo trigger for spraying the water and shampoo.
Hose group can be placed onto the motor unit by the help of hanger.
E1 - Suction hose fixing part
E2 - Shampoo hose fixing part
E3 - Shampoo hose
E4 - Clips
E5 - Suction hose
E6 - Shampoo trigger
E7 - Suction power control
E8 - Handgrip
E9 - Suction tube
E10 - Tube hook
F. SHAMPOO NOZZLE
It is used for sucking liquids on the carpets, mats, floors. Water and
shampoo is sprayed through this accessory. For floors it is used with
hard floor adapter attachment.
F1 - Shampoo nozzle
F2 - Hard floor adapter
G. MINI WETSWEEP
This nozzle is very suitable for shampooing furniture, curtains and sucking
liquids on the narrow surfaces.
H. ACCESSORIES GROUP
There are various accessories for different cleaning purposes.
H1 - Accessories Holder
H2 - Crevice Nozzle
H3 - Round Nozzle
H4 - Upholstery Nozzle
Turbo Brush
The brush has a removable brush bar cover which gives you easy access
to the brush bar and a switch which allows you to vacuum hard floors
without the risk of scratching in addition to vacuuming carpets and rugs.
T1 - Brush body
T2 - Rubber bumper seal
T3 - Brush soleplate
T4 - Small wheels
T5 - Elbow and tilt mechanism
T6 - Large wheelies
T7 - Big Brush bar cover
T8 - Spiral brush bar
12
A5 - Hepa filter
A6 - Hepa filter housing cover
A8 - Foam filter
B5 - Black seal
B6 - Clamps
B8 - Suction inlet
H5 - Nozzle
H6 - Perfume
H7 - Shampoo
Werbung
Inhaltsverzeichnis
