Installation; General Guidelines; Specifications - Velleman CAMSETW7 Bedienungsanleitung

6. Installation

1. Put the camera in the desired location and then adjust the angle.
2. Connect the adapter (DC 8V 200mA) to the camera.
3. Connect the antenna to the receiver.
4. Connect the adapter (DC 8V 200mA) to the receiver. Slide the power switch to ON position.
5. Connect the receiver to a monitor/TV with the A/V cable (yellow for video and red for audio).
6. Power on the monitor/TV and select A/V mode.
7. Use the channel button to
displayed on the monitor/TV.
8. Adjust the brightness, contrast and colour of the monitor/TV.
7. Camera Channel Set-up
The channel number for the camera is printed on
the camera. Use the channel button to select the
same channel for the receiver as for the camera.
The image is now displayed on the TV.

8. General Guidelines

• Protect the device against water and don't put objects containing water (e.g. vases) on top of the device
•
Turn off the camera/receiver if the system is not in use.
•
Use the adapter to connect /disconnect the device with/from the mains.
•
Do not cut off the DC power cable to try and use it with a different power source

9. Specifications

Operating temperature
Storage temperature
Operating humidity
Camera
Imaging sensor
Total pixels
Viewing angle
Transmission frequency
Transmission power
Modulation type
Bandwidth
Power supply
Current consumption
Effective range (line of sight)
Night Vision Range
Dimensions (W x D x H)
Weight
Receiver
Reception frequency
Intermediate frequency
Demodulation type
CAMSETW7
set the same channel on the receiver as on the camera .The camera picture is now
0 to +50°C/ +32 to +122°F
-30 to +80°C/ -22 to +176°F
85%RH
CMOS
628 x 582 (PAL); 510 x 492 (NTSC)
62°
2.400 to 2.483MHz
10mW/CE; 2mW/FCC
FM
18MHz
8V DC
80mA & 100mA (IR ON)
100m
3m
46 x 42 x 57mm (without bracket)
90g
2.400 to 2.483MHz
480MHz
FM
2 VELLEMAN