Installation - Velleman CAMCOLD11N Bedienungsanleitung

4.
Features
• vandal-proof IR camera
• manual varifocal lens with adaptive focus and zoom
5.
Overview
Refer to the illustrations on page 2 of this manual.
A light sensor
B IR night LEDs
C varifocal lens
D manual zoom
E manual focus
6.

Installation

• Choose the location for the dome camera, keeping following guidelines in
mind:
• Do not install the camera in locations where extremely high or low
temperatures, high humidity, water vapour or steam, dust or excessive
vibrations may occur.
• Avoid mounting the camera near high electro-magnetic fields as this will
influence image quality.
• Do not aim the camera at the sun or other extremely bright objects or
reflections.
• Release the hex head screw [J] with the included Allen wrench.
• Hold the mounting plate [I] and unscrew the fixation ring [H] by turning it
counter clockwise. Note that the lens enclosure [F] and positioning ring [G]
are also released.
• Use the mounting plate [I] to determine the position of the mounting holes.
• Guide the power and video cable though one of the cable slots and mount
the mounting plate [I] on the ceiling or wall with the four mounting screws
(included).
• Insert the lens enclosure [F] in the positioning ring [G] and insert both on
the fixation ring [H]. Screw the fixation ring [H] back on the mounting plate
[I]. Do not secure the hex head screw [J] yet.
• Connect the video connector [1] to a monitor (not incl.) or a sequential
switcher/quad splitter (not incl.) when connecting multiple domes.
• Connect the power connector [2] to a 12VDC power supply (not incl.)
• Manually adjust the zoom with screw [D] and the focus with screw [E]. The
location of the screws can be determined by looking at the position of the
light sensor [A].
• After setting up the desired field of observation, zoom and focus, screw the
hex head screw [J] in clockwise into the mounting base [I] to secure the
camera's position.
08.08.2011
CAMCOLD11N
F lens enclosure (ball)
G positioning ring
H fixation ring
I mounting plate
J hex head screw
4
©Velleman nv