Brother PRSFLH200 Installationsanleitung Seite 5

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3 Move the left arm to align the screw on the right
side with the mark for the embroidery frame to
be installed, and then tighten the thumb screws.
For the flat frame, align with mark 1.
1 Mark for flat frame
200 mm (H) × 200 mm (W)
(7-7/8 inches (H) × 7-7/8 inches (W))
● Please firmly tighten the two thumb screws
with the disc-shaped screwdriver included
in the embroidery machine package. The
machine will recognize the wrong frame
size, if the two screws are not tightened.
4 Hold the embroidery frame level, and then
simultaneously align both the left and right
mounts with the embroidery frame holder clips.
• The inner frame should be on top.
● Please confirm that the table is properly
installed on the machine.
Note
Note
5 Insert the embroidery frame until it snaps
into place.
1 Make sure that the pins on the left and right arms
of the embroidery frame holder fit into the
positioning slot and hole on the embroidery frame.
■ Embroidering large pieces of fabric or heavy
clothing
When embroidering large pieces of fabric or
heavy pieces of clothing, use a clothespin or
binder clip to fasten the excess fabric to the
embroidery frame so that it does not hang down
from the frame and it is not caught during
embroidering process.
Note
● Embroidering with excess fabric hanging
down from the embroidery frame may
prevent the frame from moving properly
and may result in a misaligned pattern.
3/3