Exit Setup Menu; Guidelines On/Off; Adjust Playback Volume; Camera Installation - Westfalia RVC7000 Bedienungsanleitung

Exit Setup Menu

Press the menu button (10) several times until the menu line
EXIT is marked. Now press the + button (11) or the – button (12)
to exit the setup menu.
Guideline ON/OFF
Press the guideline ON/OFF button (13) to switch the on-screen-
display guidelines on or off.

Adjust Playback Volume

In AV mode press the buttons + (11) and – (12) to set up the
playback volume of the connected video device.
Press the button audio mute (13) to mute the audio.

Camera Installation

You may mount the camera using the
license plate's top or bottom mounting
bolts or screws. Make sure that its
field of view is not obstructed. Use the
supplied wedge shaped spacer to
adjust the angle of the camera.
At some type of cars it may not be
possible to mount the camera to the
license plate. In this case, find a
different spot at the back of your car to mount the camera with
the supplied bolts and screws.
1. Loosen the bolts/screws and remove the rear license plate.
2. Insert each license plate bolt into a supplied wedge shaped
spacer (camera mounting accessories (4)), then through the
bolt holes of the camera.
3. Finally slide the remaining wedge shaped spacers through the
bolt and tighten the license plate (picture).
Camera Installation
23