Maintenance - Makita ML120 Betriebsanleitung

The following tables indicate the operating time on a single charge.
ML120
Voltage
12 V
(Note)
If you use a power checking battery on Model ML120, the power checking battery will not indicate the remaining bat-
tery capacity properly.
ML140
Voltage
14.4 V
ML180
Voltage
18 V
Storing battery cartridge
Always charge the Nickel Metal Hydride battery cartridge
before storing it when you do not use it for more than six
months.
Head angle (Fig. 3)
The head angle can be adjusted in four stages. Adjust as
desired.
Replacing bulb (Fig. 4 & 5)
CAUTION:
The bulb is very hot immediately after operation. Wait
until the bulb cools off before attempting to replace it.
First, turn the ring counterclockwise and remove the
reflector. Then replace the bulb.
Shoulder strap (Fig. 6)
Install the strap on the tool.
10
Battery cartridge
1200
1220
1200A
1202
1222
1202A
1233
1234
1235
1235A
Battery cartridge
1420
1422
1433
1434
1435
Battery cartridge
1822
1833
1834
1835
Operating time
Approx. 110 min.
Approx. 160 min.
Approx. 190 min.
Approx. 220 min.
Approx. 260 min.
Operating time
Approx. 110 min.
Approx. 160 min.
Approx. 190 min.
Approx. 220 min.
Approx. 260 min.
Operating time
Approx. 190 min.
Approx. 220 min.
Approx. 260 min.
Approx. 300 min.

MAINTENANCE

To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
Charger
DC1201, DC1470, DC1411,
DC1422, DC1439, DC1801
DC1201, DC1411, DC1422,
DC1439, DC1801
DC1411,DC1422,
DC1439, DC1801
Charger
DC1470, DC1411, DC1422,
DC1439, DC1801
DC1411, DC1422,
DC1439, DC1801
DC1411, DC1422,
DC1439, DC1801
Charger
DC1801