Maintenance - Makita ML140 Bedienungsanleitung

OPERATING INSTRUCTIONS
Charging
Charge the battery cartridge with the Makita charger before use. To remove the battery cartridge, withdraw it
from the flashlight while pressing the buttons on both sides of the cartridge. After charging, insert the battery
cartridge into the flashlight all the way until it locks in place with a little click. (Fig. 1 )
Battery
cartridge
ODeratino time
-
NOTE:
Battery cartridges 1200, 1201, 1202, 1202A can be used on ML120 if you install the set plate. Install the set
plate on ML120 with the screw provided as shown in
Fig. 2.
Battery Battery Battery Battery
&"OX.
100
min. ADDrOX. 130 min. ADDrOX.
150
min. ADDrOX. 170 min.
1200/1220 1201 1202/1202Al1222 1233
The following tables indicate the operating time on a single charge.
ML120
Battery Battery Battery
Operating time Approx. 150 min.
Approx. 170 min.
Head angle (Fig.
3)
The head angle can be adjusted in four stages. Adjust as desired
Replacing bulb (Fig. 4
81
5)
CAUTION:
The bulb is very hot immediately after operation. Wait until the bulb cools off before attempting to replace it.
First, turn the ring counterclockwise and remove the reflector. Then replace the bulb.
MAINTENANCE
To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by Makita
Authorized Service Center.