Connection Panel; English - Bang & Olufsen BeoLab 1 Handbuch

4

Connection panel

Press on both sides of the cable cover to release
it from the transmitter.
~ – Mains supply
Connection to the mains supply.
WIRELESS
Wireless status indicator.
SELECT
Press shortly to scan for un-configured
wireless speakers. Long press to start manual
configuration and then short press to switch
between speakers until the intended speaker
produces a sound during wireless setup.
STORE
Store speaker setting for a speaker and
move on to the next speaker. A long press
indicates the number of wirelessly connected
speakers in the PL status indicators.
USB B
For service only.
USB A ( )
For connection of a flash USB device for software
updates. For more information about software
updates, see www.bang-olufsen.com.

English

PL1-4
Inputs for connection of a video or audio system.
Each input has both a left and a right sound
channel, which is also indicated with a left/white
and right/red PL status indicator per input. If a PL
status indicator flashes, there is no connection to
the speaker.
B&O INPUT (YES – NO)
Input signal switch: YES is for connection of a
Bang & Olufsen system, and NO is for connection
of a non-Bang & Olufsen system.
TOSLINK
TM
Optical stereo input for connection of an audio
system. The volume of the signal must be adjusted
on the audio system.
INPUT (R – L)
Left and right line input for connection of an audio
system. The volume of the signal must be adjusted
on the audio system.
SUB – 2.1 (OFF – ON)
Subwoofer switch: ON is for connection of two
speakers and one subwoofer using stereo input
(PL1, TOSLINK or INPUT (R-L)).
OFF is selected for all other setups, such as
surround sound setups.
The product status indicator is placed on the front
side of the transmitter.
Product status indicator:
– Red (solid): The indicator is solid red shortly
when the transmitter is connected to the mains,
switches off, or when it restarts after it has been
reset.
– Green (solid): The indicator is solid green
shortly when the transmitter switches on.
– Green (flashing): A software update is in
progress during which the speakers cannot play.
Do not disconnect from the mains.
– Orange (flashing): A hardware error has
occured. Disconnect the transmitter from the
mains and reconnect it. If the problem persists,
contact your Bang & Olufsen retailer.
Wireless status indicator:
– White (solid): Speakers are connected to the
transmitter.
– White (flashing): No speakers are connected
to the transmitter.
– Green (flashing): Speakers are connecting to
the transmitter.
Product and wireless status indicators
simultaneously:
– Orange (solid): The wireless signal strength is
low.
– Orange (flashing): An error has occurred.
Disconnect the transmitter from the mains and
reconnect it. If the problem persists, contact
your Bang & Olufsen retailer.