Samsung dvd hd870 Bedienungsanleitung Seite 11

Connection to a TV (Interlace)
- Connecting to your TV using Component video cables.
- You will enjoy high quality and accurate color reproduction images. Component video separates the pic-
ture element into black and white(Y), blue(P
signals are delivered through the audio output.)
1
Using component video cables (not included), connect the
COMPONENT VIDEO OUT terminal on the rear of the
DVD player to the COMPONENT IN terminal of TV.
2
Using the audio cables, connect the AUDIO (red and
white) OUT terminals on the rear of the DVD player to the
AUDIO (red and white) IN terminals of TV. Turn on the
DVD player and TV.
3
Press the input selector on your TV remote control until the
Component signal from the DVD player appears on the TV
screen.
4
Set the Video Output to I-SCAN in the Display Setup
menu. (See pages 27 to 29)
You can use the VIDEO SEL. button to change the Video
Output mode. (See page 9)
Note
- If Video output is incorrectly set to S-Video with the Component cables connected, the screen will
turn red.
- If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 14 to 15)
- The component terminal of TV can be marked by "R-Y, B-Y, Y" or "Cr, Cb, Y" instead of "P
depending on the manufacturer. The number and position of terminals can vary depending on the TV set.
Please refer to the user's manual of the TV.
- If you set the HDMI output resolution 720p or 1080i, S-Video output cannot be used.
), red(P ) signals to present clear and clean images. (Audio
B R
RED
RED BLUE
GREEN
RED
WHITE
Audio Cable
WHITE
RED BLUE GREEN
, P
R
Component cable
(not included)
, Y"
B
11