Wilks USA RX545i Benutzerhandbuch Seite 6

RX545i
The supplied nozzles attach to the lance that screws
into the gun. These provide a variety of pressures
and patterns designed for different cleaning
applications.
Nozzles
The nozzles are stored in a panel mounted to the
handle of the washer.
Fig.7 Fig.8
Red 0°Nozzle: This nozzle delivers a pinpoint stream
of pressurized water and is extremely powerful. It
should only be directed at surfaces that can withstand
high pressure such as metal or concrete. (Fig. 7)
Yellow 15° Nozzle: This nozzle delivers a powerful
15-degree spray pattern for intense cleaning of small
areas. This nozzle should only be used on areas and
materials that can withstand very high pressure. (Fig.
8)
Green 25° Nozzle: This nozzle delivers a 25 degree
spray pattern for intense cleaning of larger areas.
This nozzle should only be used on areas that can
withstand very high pressure. (Fig. 9)
6
Fig.9 Fig.10 Fig.11
English
White 40° Nozzle: This nozzle delivers a 40-degree
spray pattern and a less powerful stream of water.
This nozzle can cover a wide area and can be used for
most general cleaning jobs. (Fig. 10)
Black / Blue Detergent Nozzle: This nozzle is used
to apply detergent and cleaning solutions. This nozzle
produces the weakest pressure of the three nozzles.
Don't forget that you can adjust the detergent flow
using the dial on the front of the machine. (Fig. 11)
To avoid damaging your cleaning surface, always start
with the lowest pressure nozzle and work up through
to the higher pressure nozzles.
Nozzle Maintenance
1.
A clogged or partially clogged nozzle can
significantly reduce water flow and cause the unit to
pulsate while spraying. To clean the nozzle:
2.
Turn off and unplug the unit from the electric mains.
3.
Turn off the water supply and relieve any pressure
trapped in the hose by squeezing gun trigger 2-3
times.
4.
Separate lance from gun.
5.
Rotate the nozzle to the narrow high impact stream
setting. This opens up the fan blades.
6.
Using the included tip cleaner, or an unfolded paper
clip, insert the wire into the nozzle hole and move
back and forth until any debris is dislodged.
7.
Remove additional debris by back-flushing water
through the nozzle. To do this, place end of a
garden hose (with water running) to end of nozzle
for 30-60 seconds.
Insert tip cleaner into the nozzle hole and move back
and forth until debris is dislodged
© Wilks-USA