NEXDIAG NexPTG-Serie Bedienungsanweisung Seite 31

Then wait for the measured value to appear on the screen of the external device.
FOR NEXPTG ECONOMIC PLUS AND
Before starting measurement, make sure that:
 all radios are switched off (radio, CB radio). If there is a CB antenna on the vehicle – remove it from the
car for the duration of the measurement;
 there are no devices nearby that generate strong electromagnetic radiation and there is no close
presence of static electric charges, as they may cause erroneous measurements;
 no measurement is made in conditions such as: presence of dust, sediments, air bubbles, high moisture,
high humidity, rain, snow;
 the tested surface is not dirty.
The device is designed to test magnetic metal (steel, galvanized steel) and non-magnetic (aluminum)
of car bodywork. The types of surface tested are detected automatically. Attention should be paid to the
correct use of the device (see below).
Then wait for the measured value to appear on the screen of the external device.
1
does not apply to Economic and Economic Plus models
NEXPTG PROFESSIONAL METERS
NexPTG
1
surfaces
31