1.2. General Content Of The Ec-Declaration Of Conformity - Milnor 30015T5E Bedienungsanleitung

Figure 1: Machine Data Plate
View of Data Plate (English text shown)
.
BIWUUL01 (Published)

1.2. General Content of the EC-Declaration of Conformity

Manufacturer Pellerin Milnor Corporation
Hereby we declare under our sole responsibility that the machinery
Type (see the declaration for your machine)
Serial no (see the declaration for your machine)
Manufacturing date (see the declaration for your machine)
is in conformity with the provisions of Machinery Directive (89/392 EEC) as amended.
Pellerin Milnor Corporation certifies that the machine(s) listed above, manufactured in Kenner,
Louisiana, 70063, USA conform(s) as stipulated by schedule of verification of ISO/DIS 10
472-1 of June 1994 Safety Requirements for Industrial Laundry Machine, Part One, Common
Requirements for All Types, ISO/DIS 10 472-2 of June 1994, Safety Requirements for
Industrial Laundry Machine, Part Two: Washing Machines and Washer Extractors, BS EN
294 of 1992 Safety of Machinery, Safety Distances to Prevent Danger Zones Being Reached by
the Upper Limbs, and EN 60204-1 of October 1992, Safety of Machinery, Electrical Equipment
of Machines, Part One, General Requirements. EN50081-1,2 Electromagnetic Compatibility.
Safety compliance to the standard is described in detail in MILNOR manual (see the declaration
for your machine).
This letter confirms that the machine(s) only meets the required aforementioned standards. It is
the responsibility of the installer/owner of the machine(s) to ensure compliance with all
requirements for on-site preparation, installation, and operation.
Our conformance to the above listed standards is certified with exceptions listed in MILNOR
Conformance Report (see the declaration for your machine).
Place Kenner, Louisiana, 70063, USA
— End of BIUUUF01 —
Book specs- Dates: 20120501 / 20120501 / 20120501 Lang: ENG01 Applic: RMN
9
Chapter 1. Machine Description, Identification, and Certification
1. Model number. See
inside the front cover of
this manual.
2. Data that uniquely
identifies your machine
3. Cylinder maximum
rotation speed in
revolutions per minute, if
applicable
4. Cylinder volume in the
units of measure shown,
if applicable
5. Piped utility requirements
6. Hydraulic oil pressure, if
applicable
7. Electrical requirements
8. Part number for
multi-unit machine, if
applicable.
PELLERIN MILNOR CORPORATION
Legend