Inhaltsverzeichnis; Transportation; Installation Location - Acson international C Serie Installationsanleitung

- Outline And Dimensions
- Unit Installation
- Electrical Wiring Diagram
- Transportation
- Installation Location
- Physical Data
- Water Piping and Fitting
- Buffer Tank (Optional)
- Electrical And Wiring
Please take note of the following important points when installing.
• Do not install the unit where leakage of flammable gas may occur.
If gas leaks and accumulates around the unit, it may cause fire ignition.
• Do not overcharge the unit.
This unit is factory pre-charged. Overcharge will cause over-current or damage to the compressor.
• Sharp edges and aluminium fin coil surface are potential location which may cause injury
hazards. Avoid from being in contact with these locations.
• The unit should be lifted using a crane. Ensure that the hanger belts are not touching panel
and the coil, top front panel (use protective panel) as shown in Figure 1.
• The bolt of the base and channel support can be removed after putting the unit on the fixed
location.
• Installation work should be done by the authorized dealer or qualified contractor.
• Make sure there is sufficient airflow around the unit.
• Vibration isolator should be provided to prevent vibration and noise from the unit.
• There should be sufficient space allocated for servicing and maintenance.
INDEX
page i - Electrical Data
page ii - Recommended Fuse And Cable Sizes
page iii - x - Phase Protector
page 1 - Fan Speed Controller (Optional)
page 1 - Refrigerant Circuit
page 2 - Special Precautions When Dealing With R407C Unit page 7
page 4 - Control Operation Guide
page 4 - Maintenance
page 5 - Troubleshooting
! ! ! ! ! CAUTION

TRANSPORTATION

INSTALLATION LOCATION

1-1
page 5
page 5
page 6
page 6
page 7
page 9
page 11
page 11
Hanger
Hanging Belt
Protective Panel
Figure 1