Installation And Mounting - Emerson CSI 6500 Machinery Health Bedienungsanleitung

Product Information / Produktinformation A6620
Analog I/O Card
1.5

Installation and Mounting

A prepared 3U slot in a 19" rack, or other Intermas−compatible enclosure, is required for
mounting the A6620 monitor. The slot must be fitted with a 48−pin plug connector (DIN 41612,
design F 48 M). The pin assignment is listed in the following table.
2 UB+ (+ 24V)
4 A (RS 485)
6 analog input 1 +
8 analog input 2 +
10 analog input 3 +
12 analog input 4 +
14 binary input 1 +
16 binary input 4 +
18 not assigned
20 current output 2 +
22 current output 2 −
24 binary output U2 +
26 binary output CC 1
28 binary output CC 4
30 binary output OUT 3
32 binary output OUT 6
Jumper RS 485
RS 485 bus operation requires an electrical terminator on the first and last bus device.
This is done with plug−in jumpers on the controller board. The figure shows the position of the
jumpers.
d
U− (0V/Common)
BP (Common) RS 485
analog input 1 GND
analog input 2 GND
analog input 3 GND
analog input 4 GND
binary input 2 +
binary input 1−4 GND
not assigned
current output 3 +
current output 3 −
binary output U2 − / U3 −
binary output CC 2
binary output OUT 1
binary output OUT 4
binary output OUT 7
b
UN+ (+24V redundant)
B (RS 485)
analog input 1 −
analog input 2 −
analog input 3 −
analog input 4 −
binary input 3 +
current output 1 +
current output 1 −
current output 4 +
current output 4 −
binary output U3 +
binary output CC 3
binary output OUT 2
binary output OUT 5
binary output OUT 8
Page 10
z
2
4
6
8
10
12
14
16
18
20
22
24
26
28
30
32