Niko 10-571 Installationsanleitung Seite 30

10-571 Installation manual internal video unit
Assigning a ring tone to a specific bell push button
It is possible to set a different ring tone per internal unit for a max. of 5 bell push buttons. That is because
the internal unit will also react to the four serial numbers that follow its own serial number.
So from the call, you can hear for whom the call is or which area is being called (e.g. practice-private,
parents-grandparents, etc.).
Program the installation with the service device (10-870) as follows:
Bell push button 1
Bell push button 2
Bell push button 3
Bell push button 4
Bell push button 5
Setting times
The following times have been programmed by default:
Speaking time after starting a call
Automatic cut-off of the call after opening the door
Time the camera image remains active
Number of times the green LED flashes if the video or call channel is busy
Time a call from an external unit or floor-bell push button remains displayed
Time an internal call launched by you remains displayed
Time the ring tone or image menu remains displayed
You can set other times via
• the power supply 10-80X
• the service device 10-870
• the relay 10-83x
Also see the manuals of the respective devices.
5. TROUBLESHOOTING
In case of problems, always first check with a multimeter whether the following voltages are present:
• between b and a: approx. +24V DC;
• between b and P: approx. +24 V DC;
• between M and P: approx. +24V DC;
• between M and V1 or V2: approx. +5V DC.
30
Serial number
Serial number +1
Serial number +2
Serial number +3
Serial number +4
Ring tone
Ring tone
Ring tone
Ring tone
Ring tone
2 min
4s
80s
3 times within 3s
30s
30s
10s
EN