Orking Instructions; Switching On/Off; Service & Maintenance; Reventive Maintenance - SUHNER ABRASIVE SAM series Originalbetriebsanleitung

3.
handlIng
3.1 w

Orking instructiOns

To achieve an optimum grinding result, move grinding
tool uniformly back and forth with light pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding tool.
3.2 s On/Off
witching
Hold the hand tool firmly. Switch on the drive.
Conduct the test run without load for at least thirty
seconds. Do not use vibrating grinding tools.
You must always hold the hand tool when it is op-
erating.
Switch off the drive when you stop working.
The tool still needs time to stop after the tool has been
switched off.
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.
4. s
ervIce
4.1 p

reVentiVe mAintenAnce

Always keep the hand tool clean and in a dry
place.
Worn chucks must be replaced.
22
/ o
PeratIon
/ m
aIntenance