Ating Data; Perating Conditions - SUHNER ABRASIVE SAM series Originalbetriebsanleitung

safety guard.
2.1.3 A
dditiOnAl hAndle
Move the additional handle to the position you want and
secure/loosen it at the wing nut.
Befor fitting, blow out the thread in the gearbox head.
2.1.4 A /
ttAching detAching the grinding tOOl
Place the mounting flange on the spindle so that the lon-
gitudinal groove is at the bottom.
Put on the grinding tool. The projecting centring collar on
the mounting flange must engage precisely in the hole in
the grinding tool.
Lock the spindle in place with a single open ended span-
ner. Tighten the clamping nut with the face pin wrench.
Follow these instructions in reverse order to detach the
grinding tool.
Use only those tools recommended by SUHNER.
You must also observe the safety instructions issued by
the manufacturer of the attachment.
You must check that the tools diameter is within the limits
and the max speed is higher than the tool's idle or set
speed.
The installed attachment must be able to rotate freely. Af-
terwards a test run must be conducted without load for
at least thirty seconds. Vibrating tools must be replaced
immediately.
2.2 r

Ating dAtA

Connection
Maximum speed Input
Maximum speed Output
Gear i=
Max wheel diameter
Spindle thread
Vibration EN 60745
Weight
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.
2.3 O

perAting cOnditiOns

Temperature range during operation: 0 to +50°C
Relative air humidity: 90% at +30°C, 65% at +50°C
G35
6400min
-1
5500min
-1
1.16:1
230mm
M14 / 5/8"
6.6m/s , K=1.5m/s
2 2
2.5kg
21