Eneral Notes On Safety; Intended; I Ncorrect Use; Eclaration Of Incorporation - SUHNER ABRASIVE SAM series Originalbetriebsanleitung

1. n
1.1 g

enerAl nOtes On sAfety

This operation manual is applicable for the hand tool
SAM.
The hand tool may only be handled by personnel
who are qualified.
It is imperative that you observe the safety instruc-
tions provided separately for the drive.
1.2 u
se Of the mAchine fOr purpOses fOr
which it is intended
The hand tool is designed intended for the pur-
pose of cutting, roughing and brushing of metal
and stone materials without the use of water.
The hand tool may only be operated with the safety
guards and the additional handle fitted!
For cutting, always work with the safety guard for cutting.
Available on request.
1.3 i
ncOrrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d

eclArAtiOn Of incOrpOrAtiOn

The manufacturer Otto Suhner AG of Industriestrasse 10,
CH-5242 Lupfig, hereby declares for the partly completed
machinery (see reverse side for type and serial no.) that
the following fundamental requirements of the Directive
2006/42/EC are applied and fulfilled in accordance with
Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1, 1.5.1,
1.5.4, and 1.6.1. Technical documentation was generated
for the partly completed machinery in accordance with
Annex VII of the Machinery Directive. Document Agent:
M. Voyame. Authorised sites are provided with this techni-
cal documentation in paper or electronic form on justified
request. This partly completed machinery may be put into
operation only when the machine in which the partly com-
pleted machinery is to be incorporated has been ascer-
tained to fulfil the conditions under the Machinery Direc-
tive. CH-Brugg, 04/2019.
M. Voyame/Division manager
2. c
2.1 A

ssemBly instructiOns

hand tools.
Use only hand tools, shafts, and grinding tools in perfect
20
s
otes on aFety
ommIssIonIng
It is imperative that you
read Sections 2 and 3 be-
fore you start operating the
condition.
Attach the hand tool to the shaft only when the drive is
switched off and has come to a stop.
Connect grinding tools only when the drive is switched off
and has come to a stop.
It is imperative that you use the guards intended for the
hand tool.
Observe the specifications applying to your country.
2.1.1 A /
ttAching detAching the hAnd tOOl
Press the locking button and insert the hose coupling into
the hand tool hole. Make sure that the locking button is
engaged.
Follow these instructions in reverse order to detach the
hand tool.
2.1.2 A /
ttAching detAching the sAfety guArd
Turn the safety guard to the position you want. The screw
must be tightened to secure the safety guard in place.
Follow these instructions in reverse order to detach the