Setting The Clock; Setting The Alarm Time - Eton TRAVELER II DIGITAL G8 Benutzerhandbuch

SETTING THE CLOCK

The clock functions in 24 hour mode only, not in 12 hour, AM, PM time.
1. Set the time zone selector onto your home time zone.
2. Press the HOME/WORLD button for about two seconds and notice that the
HOME time hour in the display flashes.
3. While it's flashing, set the HOME hour with the tuning knob.
4. While it's still flashing press the HOME/WORLD button once more and notice
that the HOME minutes in the display flash.
5. While it's flashing, set the HOME minutes with the tuning knob.
6. While it's flashing, press the HOME/HOUR button to complete the setting.

SETTING THE ALARM TIME

1. With the radio turned off, press the ALARM button (bottom right under
flip cover) for about two seconds and notice the alarm hour flashing in the
display's upper right corner.
2. While it's flashing rotate the tuning knob to set the hour, then press the
ALARM button again to make the minutes flash.
3. While they're flashing rotate the tuning knob to set them, then press the
ALARM again to make the SLEEP indicator flash in the upper left corner of the
display.
4. While it's flashing press rotate the tuning knob to set the amount of time that
the alarm stays on (from 1-90 minutes).
5. Press alarm again to finalize the setting.
Note: Alarm is activated according to your world time clock; unless, you have
rotated the time zone selector back to your home time zone.
10
Traveler II Digital G8 OWNER'S MANUAL