Canon RS-CL07 Installationsanleitung Seite 19

4
Attach the anti-fall wires
1 Loosen the left and right adjusting feet of
the projector.
2 Pass one end of the anti-fall wire (longer
wire for RS-CL10) into the square hole (A)
on the Base bracket, and then fasten the
other end to the right adjusting foot (B).
3 Pass one end of the anti-fall wire (shorter
wire for RS-CL10) into the square hole
(C), and then fasten the other end to the
left adjusting foot (D).
4 Tighten the left and right adjusting feet to
secure the anti-fall wires.
● Be sure to attach both anti-fall wires.
5
Pull cables out of the cable hole in
the ceiling
6
Attach the Joint fitting to the
Ceiling-mount bracket
Secure the Ceiling-mount bracket using the
four M5 screws removed during preparation.

B
A
WUX10 MarkII/SX7 MarkII/SX60/X700
B
A
SX80 MarkII/SX800
C
D
C
D
Direction to the
screen