Required Equipment - Losi TEN SCTE Bedienungsanleitung

Tools You Will Find Handy
In addition to the tools included with the TEN-SCTE, you will
fi nd the following both useful and in some cases necessary.
• Small fl at blade and Phillips screwdrivers
• Needle-nose pliers
• Quality .050-inch, 1/16-inch, 5/64-inch, 3/32-inch, 1.5mm
and 2.5mm hex (Allen) drivers

Required Equipment:

Electronic Speed Control - We recommend the Xcelorin
Sensored Brushless Speed Control
Motor - Any 550-sized motor
Battery - We recommend the Xcelorin 7.4V 60C 2S 6000mAh
LiPo (LOSB9877)
Charger - We recommend the Xcelorin MultiPro
LiPo Balancing Charger (LOSB9606)
Servo - Preferably Spektrum
Pinion Gear - Any Mod 1 Pinion Gear
Note: We recommend a Losi LOSA3576 16T pinion gear for 4.5T
550 can motor, or a Losi LOSA3577 17T pinion gear for 5.5T 550
can motor.
Two Channel Radio - We recommend a Spektrum DX3R or DX3S
transmitter and matching receiver.
Paint (always test the paint on material removed from the body
to make sure the paint and body material are compatible.)
®
™ Intelligent
™ S6040
Basic Electronics Installation Instructions Basic Electronics Installation Instructions
Caution: Please be sure to follow the electronics
manufacturers guidelines when installing and setting up
your radio, motor, servo, electronic speed control, and
battery.
Motor Installation: Follow diagram below
1. Install motor adapter onto motor with two supplied
M3x10mm screws.
2. Install pinion gear (recommendations supplied earlier).
3. Slide motor with adapter into motor mount, set mesh, and
tighten using 5-40 x 3/8 button head screw. Be sure to use
threadlock.
Receiver and Electronic Speed Control Installation: Receiver and Electronic Speed Control Installation:
Install with double-sided tape. Be sure to route wires so they
will not get caught in the spur gear.
Servo Installation: (use following diagrams)
1. Install servo as shown in diagram using the four supplied
4-40 x 1/2 in screws and washers. Please look at supplied
chart to determine if spacers are needed.
2. Choose correct servo horn adapter using servo horn chart
and press onto servo.
3. After servo is centered, install servo horn on servo using
the screw provided with your servo so that in the centered
position the servo horn is parallel to the servo saver arm.
5 - EN 5 - 5 - E E E N EN N N