Operation - Hisense RB400D4AD2 Benutzerhandbuch

13
Warning! When changing the side at which the door opens, the appliance must not
be connected to the mains. Remove plug from the mains beforehand.

Operation

Starting up and temperature regulation
Insert the plug of the connection
lead into the plug socket with
protective earth contact. When the
refrigerator compartment door is
opened, the internal lighting is
switched on.After the fridge has
been placed in position,wait for 5
minutes before electricity is
supplied.Don't store anything until
the temperature inside the fridge
becomes low enough.
The temperature selector knob is
located on the top of the
refrigerator compartment.
Setting 0 means:
Off.
Clockwise rotate the knob to turn on the
appliance
Setting 1 means:
Highest temperature, warmest setting.
Setting 7 (end-stop) means:
Lowest temperature, coldest setting.
Important!
Normally we advise you to select
setting of 2 or 3 or 4, if you want the
temperature higher or colder please
turn the knob to warmer or colder
setting accordingly. When you turn the
knob to colder which can lead to the
more energy efficiency. Otherwise, it
would result in more energy-
consuming.
Important!
High ambient temperatures (e.g. on hot
summer days) and a cold setting
(position 6 to 7) may cause the
compressor to run continuously or even
non-stop!
Reason:
when the ambient temperature is high,
the compressor must run continuously
to maintain the low temperature in the
appliance
0
Changing the light bulb
Warning! If the LED light is
damaged. DO NOT CHANG IT
BY THE USER!
Changing the LED light carried out by
inexperienced persons may cause
injury or serious malfunctioning. it
must be replaced by specialized
persons in order to avoid a hazard.
Contact your local Service Force
Center for help.
Before changing the LED light,
switch off the appliance and unplug
it, or pull the fuse or the circuit
breaker.
LED Light data: 220-240V,max1.5W.
To switch off the appliance, set the
temperature regulator to position "0".
Unplug the mains plug.
Press the Lampshade, and slide it
To change the LED light, undo the
screw .
Remove the bulb fixed block, change
the defective LED light .
Refit the bulb fixed block, the LED
light cover and the screw.
Put the refrigerator back into
operation.
Bulb fixed block
Lampshade
Screw
Control Box
LED light