Storing Stations Automatically - SSANGYONG Audio S009 Benutzerhandbuch

Radio
Storing a station manually
You can preset six stations for each band
(FM1, FM2 and AM).
1. Following steps 1 tot 4 in "Tuning in a station"
to tune to the frequency you wish to preset.
2. Press and hold the Number [1 INTRO] ~ [6
INFO] buttons for more than two seconds to
select the preset number.
The frequency is stored in the selected preset
number and you will hear a beep.
To preset another station, repeat these steps.
Note
• If you try to store another station using the same
preset number, the previously stored station will
be replaced.
Tuning in a station

Storing stations automatically

The Unit selects the station with the strong signals within the selected band and
stored them in the numerical order of their frequency.
Up to six stations can be stored in current selected band.
1. Press BAND button repeatedly to select the
band. FM1 FM2 AM FM1 ...
2. Press and hold AST buttons for more than
two seconds.
Scanning frequency will be appeared on the
display.
The unit stores stations in the order of their
frequencies on the number buttons.
Note
• If only a few stations can be received due to
weak signals, the unit will store the only available
stations to the number buttons and will store the
latest frequency to remains number buttons.
• When a number is indicated in the display,
the unit starts strong stations from the start
frequency of its band.
11
Audio S014