Adjustment Of Hob Per Gas Types; Flow Setting Screw Should Be Tightened In Lpg Conversions As It - Kuppersberg TG 699 Handbuch

ENGLISH
Make the connection
no pressure will be applied on the
connection records and piping. Make
sure that the pipe will not cause any
clogging or contact with the sharp
corners.
Note that the gas hose will not be
laid through hot areas.
NOTE: Replace the gas hose of your
hob at 4 to 5 years even if it will be
undamaged.
NOTE: Check whether any gas
leakage after the connection with soap
and water. Do not ever use flame.
Make sure that no additional weight
to be applied on the gas hose.
And apply the following order for
installation:
1. In the order; male adaptor
cylindrical, gasket, female gas adaptor,
conical-cylindrical
cylindrical components,
2. Tighten connection place with the
keys so that the pipes will be in proper
position,
3. Attach coupling to the main gas
source by using hard copper pipe or
flexible steel pipe.
WARNING; Final Check whether
any leakage exists at the pipes with a
solution with a soap, and do not ever
use flame.
6.5. ADJUSTMENT OF HOB
PER GAS TYPES
These instructions are prepared for
specialist personnel having required
competence, the installation of the
so that
or cylindrical
TECHNICAL PASSPORT
equipment should be suitable as per
the applicable standards.
 All gas related works should be
conducted when the electric connection
was cut.
In order to convert the hob, remove
the burner plates and flame circles
thereon. Replace the injectors as per
the followings, and change them with
the injectors with suitable diameters
defined in the user's manual. Conduct
the works with a plain tip screwdriver
at a position to see valve setting screw
by removing the switches of the hob
and rubber seals. In order to set the
low flame level, turn the gas setting
screw on the valve to have minimum
gas setting flow. Do this setting after
installing the burner component of the
burner, burning the burner and bringing
the switch setting to minimum.
Flow setting screw should be
tightened in LPG conversions as it
should be released for conversion from
LPG to natural gas.
Gas hob
37