Starting The Appliance; Â In Order That The Hob Will - Kuppersberg TG 699 Handbuch

TECHNICAL PASSPORT
Gas hob
After realization
complete the conversion transaction
by connecting the rubber seals and
switched in the same order.
These instructions
used by an authorized service. The
products should be installed as per
the regulations in force and in proper
manner. Before
transaction the electrical connections
of the hob should be cut by no means.
The type label on the hob indicates
the gas type planned to be used with
the unit.

6.6. STARTING THE APPLIANCE

FIRING OF BURNER
If your hob does not have built in
lighter or during black out place the
naked flame over the burner and push
the switch to bring it to the desired
position with
movement. Gas adjustment should
be between maximum and minimum
levels, it should not be realized between
maximum and off positions. To close the
burner turn the switch clockwise till to
reach "off" position.
MODELS EQUIPPED WITH
LIGHTER SWITCH (Automatic
ignition)
In order to burn one of the burners,
press the switch down and bring the
switch to maximum position. When it
burns, flame is adjusted to the desired
intensity with the switch.
38
of the hob,
should be
conducting any
counter-clockwise
RIGHT
Figure 6.
 In order that the hob will
operate properly the grills and burner
components should
positioned.(Figure 6)
 Make sure that the flame of your
burner is in blue color and work quietly.
If the burner will burn in yellow color
or work with voice make sure that all
burners fit properly. If the flame color
does not change to blue color then
apply the authorized service.
ENGLISH
WRONG
be properly