Maintenance And Cleanings - Kuppersberg TG 699 Handbuch

TECHNICAL PASSPORT
Gas hob
8. MAINTENANCE AND
CLEANING
Please comply with the following
rules before cleaning and maintenance.
 Close the unit for safety purposes.
If your device is set to natural gas setting
close the valve. For LPG hobs close hood.
 Take out the plug of your unit
from wall socket.
 If the hob is hot wait until it will
be cooled.
 In order that you use the glass
hob and grills for longer periods you
need to clean them with appropriate
cleaning agents at certain intervals.
 Cleaning on stainless surfaces
should be conducted in accordance
with the steel surfaces, and the surface
should be dried preferably with a soft
leather part.
 In order to avoid any damage to
the burning system do not use burning
system when the burners are not
installed.
 After the
cleaning providing plug and safety
system, clean it to place burners in
suitable manner.
 Wash the upper burning heads at
certain intervals with water and clean
and dry the gas channels with brush. Pay
attention to install the burning heads on
their places.
 When you clean the burner do
not use acid, thinner, benzene or similar
chemical.
 You need to clean your glass
hob and its grills with suitable cleaning
agents in order to use it for longer
period.
44
thermo-coupled
 It should be cleaned with suitable
cleaners for stains and oil.
 Harsh cleaning agents, stain
removers and detergents, wire wool and
sponge should not be used.
 No cold liquid should be poured
on the glass surface or the burners when
they are hot. The glass may crack due to
thermal shock.
Clean the hob regularly after waiting
for cooling after each use in order to
keep your hob at the best manner.
Do not take out the control switches
in any manner during cleaning.
Enamel Parts
All enamel parts are used by using
water with soap and suitable detergents.
The hob should be dried thoroughly
after the process.
Pan Supports
Grills may be washed in the
dishwasher.
Burner
The burners consisting of two parts
may be leaned by using detergent.
The burners should be dried after
cleaning process and placed their places
delicately.
In the electronic ignition models, the
electrode should be left cleaned all the
time.
In the safety valve models, the valve
should be cleaned for failsafe operation.
After completion of the process,
the burners should be placed in their
placement to their places.
The burning system should not
be used when burners are not in their
places to avoid damage to electronic
ignition system.
ENGLISH