Troubleshooting - Velleman CAMCOLD5 Bedienungsanleitung

Example: Setting preset 15 to camera n° 5.
o Press 5 and then press the CAM key to select the camera.
o Move the P/T and the lens to the desired position.
o Press the F1 key.
o Press 8.
o Press 15.
o Press PRE to confirm your selection.
d. Running the Preset
• Select the desired camera number.
• Define the preset (1 - 32). The default preset is 1.
• Press the CALL key. The corresponding preset will be displayed on the screen.
Example: Setting camera n° 3 to preset 6.
o Press 3.
o Press the CAM key.
o Press 6.
o Press the CALL key.
o Preset 6 of camera n° will be displayed.
e. Pausing a Running Preset
• Select the desired camera ID (1 – 63).
• Press the HOLD key or tilt the joystick. The auto running preset will be paused.
Example: Pausing the preset of camera n° 4.
o Press 4.
o Press the CAM key.
o Press HOLD or tilt the joystick. The preset of camera 4 will be paused.

8. Troubleshooting

Problem
The camera does not react when
connected to a power supply.
Light and image cannot be
controlled.
The camera cannot be controlled or
is moving erratically.
Fluctuating image.
Dimmed image.
CAMCOLD5
Possible Cause
Wrong connection.
Power deficiency.
Wrong camera ID or baud rate.
Wrong protocol.
Wrong RS485 terminator setting.
Non-compatible protocol.
Wrong camera ID.
Power deficiency.
Wrong RS485 terminator setting.
Wrong zoom setting.
Power deficiency.
Focus is manually set.
Dirty lens.
- 5 -
Solution
Check the connection.
Check the power supply.
Reset the camera ID or baud rate.
Reset the protocol.
Reset the RS485 terminator setting.
Reset the DIP setting.
Reset the camera ID.
Check the power supply.
Reset the RS485 terminator setting.
Reset the zoom setting.
Check the power supply.
Run a preset or set the camera.
Clean the lens.
VELLEMAN