Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Maintenance
3
Do not use oil or spirits to lubricate or clean the Javelin/Practik,
some of the plastic components and bearings may be damaged.
Cleaning and lubrication
It is good practice to keep a dust sheet over the Javelin/Practik if it is not to be used for
extended periods. In any event regularly clean it with a dry cloth, to remove any
stubborn stains use a cloth dampened with a little water/detergent.
Should the cutting head slideway require lubrication use a silicon spray or impregnated
sponge.
Cutting Head Bearings
The bearings that control the sliding motion of the cutting head are manufactured from a
high grade polymer and under normal use will last for an extremely long time. As they
settle into position you may find a slight amount of side play, this can be removed by
tightening the two adjustment screws.
Should you require any advice or technical information please contact your
distributor or Keencut direct.
Werbung
