Every 200 Hours - grandimpianti C 200/51 Installations- Und Gebrauchsanweisung

Note: all servicing must take place with the machine off, cold cylinder and selector
in 0 position.
5.1 Every day
, before start-up (machine cold and cylinder stopped)
 Check the contact of the sensor with the cylinder and visually check that there is no
foreign body between the two.
In order to do this, exercise pressure on the sensor with your hand.
 In the case of a steam-heated machine, after having very slowly opened the
pressure, it is necessary to drain the condensates of the circuit by opening the drain
valve situated on the steam return piping.
5.2 Once a week
 Clean the inside of the sensor by rocking the sensor for a quarter turn, and remove
by hand the fibres and fluff that have settled under the sensor. Return the sensor to
its initial position.
 Remove the top panel (fixed with 2 screws, 6-sided male key of 5 mm) and check
for the presence of bands between the pressing roller and the band guide.
If a band is missing, it must be imperatively replaced by a band of the same grade
(special high temperature band).
Note: the bands are deliberately slack; when replacing them, take particular care not to
stretch them as this will cause them to break prematurely.

5.3 Every 200 hours

Cleaning:
Check the cleanliness of the sensor by making it rock 90 degrees and then put it

back in place and ensure that it is correctly resting on the cylinder.
 Clean the demister turbines without forgetting the ventilation cage and the exhaust
pipes (especially the elbows).
 Clean the ventilation grids of the ventilation and drive motors.
 Clean the blades used to release the laundry from the cylinder at the level of the
intake tub.
 Clean the cylinder as soon as a layer of lime or washing powder deposit appears
(generally white).
5. PERIODICAL SERVICING
, before start-up.
DOC MACHINE Ø50.0-EN by PS on 19/06/2015, Page 28 of 33