Procedure To Be Followed In The Case Of Breakdown Or Poor Functioning - grandimpianti C 200/51 Installations- Und Gebrauchsanweisung

To start the work, it is essential to wait for the cylinder of the machine to reach a

temperature close to the desired temperature (the heating light goes off as soon as
the temperature is reached).
For ironing small laundry items, it is essential to work successively over the entire

ironing length, in order to do a good job and lengthen the life of the ironing belts
which would otherwise risk becoming quickly worn out.
 In order to ensure perfect drying and hot pressing of the laundry, the speed of use
and the temperature must be adjusted according to the nature and humidity of the
laundry to be ironed.
Important: at the end of the job, press STOP and the machine will automatically stop as
soon as the indicated temperature is below the programmed stoppage temperature (80°C
by default).
Imperative: never stop the machine if the temperature is equal to or in excess of 80°C (risk
of wear of the belts).
Lastly, isolate the ironing belts from the cylinder by placing a thick dry cloth inside it (or a
dry sheet folded into two) which you will iron at the top and bottom.
Do not leave damp laundry in the machine as this would lead to corrosion of the cylinder.

3.2 Procedure to be followed in the case of breakdown or poor functioning

Power cut: attention in the case of power cut (stoppage of the machine with the
cylinder hot) it is essential to immediately isolate the ironing belts from the cylinder.
In order to do this, enter a thick and very damp cloth (only just rinsed) into the
machine by manoeuvring it with the aid of the handle provided for the purpose.
Engage the handle into the orifice situated in the right panel of the machine or at the
front to the right.
Other breakdowns
 If the machine won't start (cylinder not rotating) or if the machine has stopped
suddenly, check that no emergency stop has been engaged including the safety
tablet just above the intake belts) as well as the presence of the butterfly nut of the
safety handle. After having unlocked the emergency stops, restart the machine by
pressing the START button.
 If the intake safety tablet (tablet above the intake belts) is activated while the machine
is in operation, the machine stops and you must then immediately restart the
machine by pressing the START button (to avoid wear on the belts).
DOC MACHINE Ø50.0-EN by PS on 19/06/2015, Page 19 of 33