Use Of The Machine - grandimpianti C 200/51 Installations- Und Gebrauchsanweisung

4.3 Use of the machine

start-up
Press the START button to start up the machine:
 the displays light up showing the current temperature and programmed speed (see
chapter entitled "Cylinder rotation control")
 the VMS light comes on (VST always on)
the ventilator starts up

 the rotation of the cylinder is activated
 after 15 seconds, heating is authorised
stoppage procedure
Press the STOP button to turn the machine off.
The stoppage procedure is in accordance with the detected temperature.
if the temperature is  Automatic stoppage temperature TA (80°C by default), the

machine goes off.
 if the temperature is > TA temperature, only the heating is cut off. When the
temperature falls to the TA temperature, the machine will stop completely.
The temperature display and the VMS light flash throughout this period.
The TA value may be programmed in the factory or during installation (see "Programming of
parameters").
START
STOP
DOC MACHINE Ø50.0-EN by PS on 19/06/2015, Page 22 of 33