Care And Handling; Warranty; Accessories - Makita SKR301 Bedienungsanleitung

2. After a few seconds, release On/Off key.
3. The X LED indicator (23) will blink, then the Y LED (21). Release
the Auto/Man key.
4. The Z LED (19) will blink rapidly, indicating laser is ready to be
calibrated in Z axis.
5. Move the beam until it's vertical and parallel to the plumb line
using (16) or (17) on the laser or (2) or (3) on the detector or remote.
Move the laser slightly so that the beam is over the plumb line for the
final check.
Saving the calibration
The laser is now calibrated in Z axis. Press (14) on laser or (5) on
detector or remote to save the calibration data. If you don't wish to
save the calibration, press the On/Off Key on the laser.

4. Care and handling

C A U T I O N : Use of controls or adjustments or perf o rmance of pro-
cedures other than those specified herein may result in hazardous
radiation exposure.
1. The SKR301 is a precision instrument which must be handled with
care. Avoid shock and vibrations. Always store and transport the
laser and accessories in the carrying case.
2. Although weather resistant, you must always keep your laser and
its accesssories dry and clean after using. This will increase the bat-
tery life.
3. Do not store your laser at temperatures below -4°F (-20°C) or
above 176°F (80°C), because the electronic components could be
damaged.
4. Do not store your instrument in its case if the instrument or the case
are wet, to avoid water condensation inside the instrument.
5. To maintain the precision of your laser, check and adjust it
r e g u l a r l y.
6. Keep the lenses of the apertures (2) and (3) clean. Use a soft cloth
and glass cleaner.
7. It is recommended to regularly charge the batteries (for recharge-
able version only). Nevertheless, make sure to charge them only
when they are out of power or becoming so. Recharging batteries
that are still useable will shorten their capacity.
12
5. Wa r r a n t y
Your SKR301 laser is guaranteed to be free of manufacturing defects
for a period of one year. Any abnormal usage or if the instrument
has been subjected to shock will void this warranty.
Under no circumstances will the liability of the manufacturer exceed
the cost of repairing or replacing the instrument.
Disassembling the instrument by other than qualified technicians will
void this warranty. Specifications subject to change without notice.

6. Accessories

6.1 Combination detector and
laser remote control
For grade rod or handheld applications. Can also be used with
the magnet mount to attach to metal studs for exterior curt a i n
wall alignment or to ceiling grids for acoustical ceiling leveling.
Magnet Window for remote's
Level vial
LCD
screen
(front)
Detection
window
infrared signal
On-grade
alignment notch
13