Remote Control - Makita SKR301 Bedienungsanleitung

• Detection mode
1. Press the On/Off key to turn on the detector.
2. Press the middle key to select the accuracy (deadband).
3. Press the top key to select the sound level.
4. Turn the detection window towards the laser beam, and move
the detector up or down according to the information given on
the LCD display. There are 5 channels of information, or grade
indicators.
A down arrow indicates you must move the detector down to
reach the laser reference; an up arrow, move it up. When a hor-
izontal line appears on the display, the detector is at the same
level as the laser beam.
5. Press the On/Off key to turn the detector off. It will automati-
cally shut off after 10 minutes if not used (and give a warning
beep).
6. Keep the detection window clean, using a soft cloth and glass
cleaner.
• Remote control mode
If in detection mode, press On/Off to change to the remote control
functions.
If the detector is not on, press any key (except the On/Off) to use it
as a remote control for the laser.
The remote can be used to stop or start rotation, increase or
decrease rotation speed, and move the beam or square shot. It also
controls scanning and electronic calibration.
• Specifications
Range*
Accuracy*
B a t t e ry life
E n v i r o n m e n t a l
Size
* Varies with laser used. Actual accuracy depends on beam diameter and
distance to the laser.
16
500 ft. (150 m) in detection mode
100 ft. (30 m) in remote mode
Fine ± <1/16" (1 mm)
Standard ± 1/8" (2.5 mm)
50 hours; 9V alkaline
Waterproof (IP66+)
6" x 3.25" x 1.5" / 1lb
(15 x 8 x 3.5 cm / 450 g)

6.2 Remote control

The Remote Control stops, starts, or changes direction of laser rota-
tion, and moves the square shot left or right. It also controls scan-
ning and calibration.
An AA alkaline battery (1.5V) ensures 50 hours of continuous use.
To open the battery compartment, push the tab at the top up, in the
direction of the arrow (with a screwdriver).
Beam or chalk line mode
1
2 S t a rt minimum rotation speed
Move square shot left
3 Move square shot right
4 Rotation and speed control left
5 Rotation and speed control right
6 AA Battery
To use the remote for calibrating, see pages 10-12.
Remote window
5
4
6 Battery location
S c a n n i n g
Scan On / Off
Increase scan length
Decrease scan length
Aim scan left
Aim scan right
1
2
3
17