maniquick 2265 Gebrauchsanleitung Seite 67

CoNDItIoNs foR sERvICE uNDER guARANtEE
1. SANICO Srl guarantees the absence of faults and mechanical de-
fects and the completeness of the product when it is sold.
2. Repairs can be done only at Service Centres authorized by SANI-
CO Srl or by the Authorized Distributor in the country where you
have purchased the appliance.
3. The duration of the period of guarantee on the materials and on
manufacturing and operating defects is 2 years with effect from
the date of sale, subject to all the conditions for the Purchaser
shown in the Instructions for use. The obligations of guarantee
do not cover expendable materials: electrode cups, elastic bands,
power supply cables etc..
4. Complaints relative to the product must be presented directly to
the authorized service centre. The service centre, on the basis
of an agreement with the Vendor, is competent to establish the
cause and nature of the fault. The product will be replaced only if
it cannot be repaired.
5. The owner of the product will provide autonomously for deliver-
ing and collecting the product from the place of the repair under
guarantee.
6. The time necessary for the repair under guarantee will be subject
to the degree of seriousness of the fault.
7. The responsibility of SANICO Srl under these conditions of guar-
antee will be limited to the amount paid by the Purchaser for the
product in question.
the guarantee on the product will not be applied in the following
cases
• certificate of guarantee filled in incorrectly or falsified; serial num-
ber (if applicable for the specific product) damaged or removed;
• absence of commercial and financial documents (cash receipt, de-
livery note) proving the purchase;
• opening or repair of the product by the Purchaser or by an unau-
thorized Service Centre;
• defects following failure by the Purchaser to observe the rules for
use, storage and transport of the product shown in the relative
technical and regulations documentation, in which case the regu-
lations of the aforementioned documentation which have been
infringed must be specified;
Rev.4 02-2013