Including The Greenlinkbox Elt Into An Existing Local Network - Fancom GreenLinkBox ELT Anleitung

GreenLinkBox ELT
4.2

Including the GreenLinkBox ELT into an existing local network

Connect the GreenLinkBox ELT to a local network card of the PC using the blue network cable (patch cable). The
figure below shows the connection scheme.
Disconnect the power before installation.
Figure 2: Connection scheme to connect the GreenLinkBox ELT to the PC with a switch / router.
If you already have an existing network you can make the GreenLinkBox ELT part of this network. Therefore you
have to determine if it is necessary to change the network settings. If the network has the same IP-address range as
shown in the table below you do not have to change settings. The GreenLinkBox ELT can then be connected to a
free port in the network using a normal network cable (not the supplied yellow cross cable). If the network has a
different IP-address range as shown in the table, the standard IP-address of the GreenLinkBox ELT must be
changed (see paragaph 5.2.2).
IP-Address range
192.168.xx
192.168.2.x
Subnet mask
255.255.0.0
255.255.255.0
Connecting the GreenLinkBox ELT
GB 6