Safety Instructions And Warnings - Fancom GreenLinkBox ELT Anleitung

GreenLinkBox ELT
2.

Safety instructions and warnings

Read the safety instructions, regulations and conditions carefully before installing and/or using the system. Installing
the device and remedying any malfunctions must only be carried out by an authorized installer, according to the
prevailing regulations. The guarantee will not apply if this product is built into a switch box in any way other than that
indicated by Fancom.
The network module is a piece of electronic apparatus. There is always a risk of a malfunction occurring.
Fancom has made every effort to ensure that an alarm is given in the event of an emergency.
Unfortunately, a 100% guaranteed cannot be provided as not all circumstances are under Fancom's
control. Fancom cannot be held liable for any damage caused by incorrect settings and/or non or partial
functioning of the entire installation. Ask your installer if the alarm outputs of each control computer have
been connected to a separate alarm circuit.
Inspect the network module regularly for any damage. Report any damage to your installer immediately.
A damaged control computer is dangerous!
Do not use running water (high pressure cleaners) to clean your control computer. The network module is
water resistant, but not waterproof! Do not switch off the network module when houses are unoccupied;
otherwise there is the risk of condensation forming in the network module.
When mounting the computer, the following should be observed:
Never mount the network module near water pipes, drainage pipes etc.
Never mount the network module in a place where the weather has direct influence (not in the sun, or in
places where the temperature can rise sharply, etc.).
Never mount the network module in a humid and/or dusty room and certainly not in the room where the
animals are present.
No condensation may take place in or on the network module.
Use the holes behind the cover screws on the corners of the box to securely fasten the network module.
Use gland nuts to connect the network module. Use the sealing plates supplied to seal the gland nuts
which are not used. Seal all gland nuts after connection to prevent the entry of dust, aggressive gases
and/or humidity.
To protect against lightning, place an over voltage protection device in the power supply of the network
module.
Take precautions against electrostatic discharge (ESD) when working on the control computer. Ensure
the workplace is clean and dry.
Use the wiring/cables indicated on the connection diagrams and follow all instructions (see installer
manual). Only apply power after the wiring has been connected correctly. Incorrect connections can
cause permanent damage. Before a new fuse is placed, the cause of the defect should be remedied by an
authorized installer. Only replace a defective fuse by a fuse of the same type (see connection diagram).
Safety instructions and warnings
GB 2