Cleaning And Care; Maintenance; Adjustment Of The Quick -Fastener - LAS PREMIUM 12011LAS Bedienungsanleitung

Cleaning / Maintenance / Adjustment of the quick -fastener

Cleaning and Care

The bicycle carrier can be cleaned with a mild cleaning agent, with
warm water and/or a soft cloth.
First remove any coarse dirt and dust. Do not use any solvents or
similar cleaning agents, since these can damage the bicycle carrier.
Leave the bicycle carrier to dry on its own. Do not use any electrical
driers or other heating equipment to speed up the drying process.
Clean the bicycle carrier regularly when used in coastal areas or
in winter conditions in order to wash off any salt and prolong the
service life of the bicycle carrier.
Store the bicycle carrier in a dry and protected area when not used
for extended periods (e.g. over winter) in order to prolong the
service life of the bicycle carrier.

Maintenance

Check the bicycle carrier for wear before the start of every journey.
Defective metal parts and straps in particular must be replaced.
Please refer to our customer service for the replacement of parts.
Any modification of original parts and materials or the construction
of bicycle carrier can adversely affect its safety and serviceability.
The steel parts of the bicycle carrier are protected in the works
against corrosion by a powder paint coating. If this paint coating is
damaged, please have the damage rectified professionally as soon
as possible.
Under normal conditions and use, the bicycle carrier only requires
cleaning, and is otherwise maintenance free.
30

Adjustment of the quick -fastener

Carry out this maintenance operation only if the bicycle carrier
cannot be fitted firmly to the trailer coupling, as described in the
chapter "Fitting".
Remove the bicycle carrier from the trailer coupling, as
4
described under "Dismantling".
Remove the dust protection cap.
4
Loosen the locking nut slightly, as shown in the illustration.
4
Screw in the setting screw one quarter of a turn.
4
Tighten the locking nut.
4
Check whether the carrier is now firmly seated on the
4
trailer coupling, as described under "Fitting". If not, repeat
the above steps.