AEG IKE85473FB Benutzerhandbuch Seite 17

6.4 FlexiBridge Max Bridge
mode
To activate the mode touch
see the correct mode indicator . This
mode connects all sections into one
cooking zone. To set the heat setting use
any of the two control bars on the left
side.
Correct cookware position:
To use this mode you have to place the
cookware on the four connected
sections. If you use cookware smaller
than three sections the display shows
and after 2 minutes the zone switches off.
Incorrect cookware position:
until you
6.5
This function allows you to adjust the
temperature by moving the cookware to
a different position on the induction
cooking area.
The function divides the induction
cooking area into three areas with
different heat settings. The hob detects
the position of the cookware and adjust
the heat setting corresponding with the
position. You can place the cookware in
the front, middle or rear position. If you
place the cookware in the front you get
the highest heat setting. To decrease it,
move the cookware to middle or rear
position.
General information:
• 160 mm is the minimum bottom
diameter of the cookware for this
function.
• Heat setting display for the left rear
control bar shows the position of the
cookware on the induction cooking
area. Front
PowerSlide function
Use only one pot when you
operate the function.
, middle
ENGLISH 17
, rear