Zhermack QUASAR serie Handbuch Für Gebrauch Und Wartung Seite 143

MAINTENANCE AND USE MANUAL
Should any of the anomalies described below occur try setting the situation right, as
far as is permissible, by following the instructions contained in this manual. Should
the problem persist contact your Authorised Servicing Centre.
p
Roblem
Infra-red lamp
does not work.
Infra-red lamp comes
on but
does not weld.
Job-holding pan
does not respond
to joystick
commands.
QUASAR/QUASAR PLUS
EN
CAPITOLO 10: TROUBLESHOOTING
PROBLEMS, CAUSES AND REMEDIES
C
ause
1. Plug not inserted properly.
2. Mobile protection screen
not closed properly.
3. Mechanical pointer not
positioned at limit stop.
4. power adjuster not set to
"zero".
5. Main switch damaged.
6. Infra-red lamp burnt out.
7. Electrical system damaged.
8. Fuses blown.
1. Piece is not positioned at
exact heat focus point.
2. Infra-red lamp damaged.
3. Cover not perfectly clean.
1. Mobile support damaged.
2. Mobile support jammed by
foreign body.
3. Joystick control damaged.
4. Mobile support needs
lubricating.
WARNING
R
emeDy
1. Insert plug in socket.
2. Close mobile protection screen.
3. Position mechanical pointer correctly.
4. Set power adjuster properly.
5-6-7-8. Contact Authorised
Servicing Centre.
1. position parts to be welded at the
exact heat focus point. If problem
persists contact
Servicing Centre.
2-3. Contact Authorised Servicing
Centre.
1-2-3-4. Contact Authorised
Servicing Centre.
9.1
9.2
Authorised
143 of 296