Zhermack QUASAR serie Handbuch Für Gebrauch Und Wartung Seite 136

10
15
Figure
If the power adjuster is not in the correct position the safety system stops the
lamp being switched on in order to prevent erroneous thermal stress and allow
the user to adjust the intensity to the type of weld to be effected.
16
Figure
17
Figure
once the optimum welding temperature has been reached the solder will melt in just a few seconds.
once you see that solder fusion has started use the joystick to raise the platform about 2-3 mm so as
to shift the contact point of the parts to be welded to the exact thermal focussing point.
Monitoring this procedure though the protective screen allows the user to determine when the two
parts have been joined.
136 of 296
EN
Fig. 15: turn the power temperature controller (10)
anticlockwise as far as it will go and check that it is set to
"zero".
Fig. 16: grip the side handles and lower the protective
screen.
Make sure that the screen is closed
properly: if the screen is open the safety
system will stop the lamp being
switched on.
Fig. 17: Press the START button (7).
act on the power controller (10) gradually until the
desired temperature setting is indicated on the gauge
(2).
Welding progress can be checked by
looking through the protective screen.
MAINTENANCE AND USE MANUAL
QUASAR/QUASAR PLUS