CAME TH/PLUS Benutzerhandbuch Seite 28

Algorithm :
Diff
PI 0
Properties
PI 2
G
The proportional integral setting lets you manage a greater variety of systems, compared to the thermal differential setting.
And, it is especially suited to manage floor-installed and radiating systems. The gap between the room and temperature and
the set temperature will only be of a few tenths of a degree, to ensure more precise adjustments.
Cycle
Program
duration
PI0 5 minutes
PI1 10 minutes
PI2 5 minutes
PI3 20 minutes
Press button to save the configuration
Thermal Parameters
Temperature Gap
Humidity Gap
Properties
Living room
Humidity control
H
Temperature Gap:
Properties
I
PI
PI 1
PI 3
Minimum ON time
1 minute
1 minute
1 minute
2 minutes
and confirm your choices on the pop-up window.
8
9
When you choose the proportional integral algorithm, you
have four preset programs available to choose from (see
table).
This type of setting enables the device to reduce system
powering-up times, as the room temperature approaches the
set temperature. This results in remarkable energy savings
while maintaining optimal comfort levels.
Proportional Band
1.0 °C
Basic system with gas burner, zone valve
1.5 °C
1.5 °C
1.5 °C Floor-installed radiating systems, cooling
Recalibrate the temperature and humidity sensor.
If the device is not properly measuring the temperature and
humidity, by pressing areas
data settings: the temperature can be changed by ±2 °C,
in increments of a tenth of a degree, and, the humidity by
±10%, in increments of 1%.
Use buttons to set the new value to apply to the sensor-de-
tected data.
Do the same for the humidity sensor-detected data.
Save the new values by pressing button
your choices on the pop-up window.
System type
Fan coils
and traditional radiators
Electric radiators
and you can change the
8 9
and confirming