Setup And Interconnection; Quick Startup Guide - Stryker SIDNE Berchtold ChromoVision HR24 Benutzerhandbuch

Setup and Interconnection

Quick Startup Guide

This section outlines the startup instructions for experienced users. Refer to the
relevant section(s) of this manual for further details.
1. Power off the Berchtold® Camera and SIDNE®.
2. Connect the Berchtold Camera to SIDNE.
• Connect the device adapter cable to the Berchtold ChromoVision®
Camera.
• Connect the device adapter cable to the EDAM.
• Connect the SIDNE interface cable to the EDAM.
• Connect the SIDNE interface cable to SIDNE.
• Mount the EDAM.
3. Power on the SIDNE console.
4. Install the Berchtold ChromoVision Camera Driver 1.0 upgrade. SIDNE
will restart.
5. Wait for SIDNE to say "SIDNE ready" before powering on the Berchtold
Camera.
Caution SIDNE should say "Overhead Camera Connected" and the
EDAM LED should flash green within 20 seconds of powering
on the Berchtold Camera. A different LED output may indicate
device problems. If the LED does not flash green
after 20 seconds, refer to the "Troubleshooting" section of this
manual for instructions.
6. Power on the Berchtold Camera. This completes the installation
procedure.
EN-5