Sidne Feedback Messages; Notes On Operation - Stryker SIDNE Berchtold ChromoVision HR24 Benutzerhandbuch

SIDNE Feedback Messages

SIDNE® Voice
Message
"Connected"
"Disconnected"
"White Balance
Complete"
"Focus Automatic/
Manual"
"Shutter Automatic/
Manual"
"Overhead Camera"

Notes on Operation

1. Continuous Commands
• The continuous commands on the Berchtold ChromoVision Camera
are Zoom In, Zoom Out, Rotate Left, and Rotate Right. The following
notes relate to the operation of continuous commands:
• While the camera is executing any continuous command initiated by
the SIDNE interface, all commands on the tablet interface and all
commands on the voice interface, except "Stop, " will be disabled.
The camera will not respond to new commands at this point.
When the user says "Stop, " or releases the button on the tablet,
all commands on the voice and tablet interfaces will be enabled.
The camera will now be ready to accept new commands.
• Hold down the tablet button for two seconds to execute any
continuous command on the tablet interface.
EN-12
Berchtold ChromoVision Camera is powered on and
connected to SIDNE
Berchtold ChromoVision Camera is connected to SIDNE
and then disconnected or turned off
The Berchtold ChromoVision Camera has completed a white
balance
The Berchtold ChromoVision Camera focus is in Automatic/
Manual mode
The Berchtold ChromoVision Camera shutter is in
Automatic/Manual mode
Added as a prefix to the above messages, when a feedback
message is announced while not in the ChromoVision®
Camera Voice Command menu. added as a prefix to the
"Connected" and "Disconnected" messages
Definition