Herunterladen Inhalt Inhalt Diese Seite drucken

Scott Safety FH4 Gebrauchs- Und Wartungsanleitung Seite 15

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 17
DOFFING
CAUTION
Do not remove the headtop until you are
in a safe and hazard free zone
Once free of any hazard switch off the
blower
Loosen the helmet handwheel (see Fig. 2)
Pull the face seal away from under the
chin and off the face
Pivoting the mask away from the face, lift
the headtop off of the head
Place the headtop onto a clean surface
Remove the PAPR in accordance with the
Operating and Maintenance instructions
Proceed with after use cleaning and
storage
AFTER USE CARE
Note
If during use the equipment may
have become contaminated by hazardous
substances, the contamination must be
identified and properly removed or the
contaminated
components
replaced before next use.
Disposal of the contaminated components
must be carried out in accordance with
local regulatory requirements.
Inspect the headtop for worn, ageing or
damaged components
Carefully wipe clean the headtop with a
warm water solution containing a mild
detergent
It is recommended that headtop visors be
wiped clean with Distel
If necessary, wash the outside of the
breathing hose carefully using warm water
solution containing a mild detergent
Ensure the breathing hose connections
are free from all dirt or debris that could
prevent an effective seal with the blower
Once clean all components must be left
to dry naturally.
must
be
wipes
®
STORAGE
Device must be protected from damage
during transportation.
When not in use the equipment should be
stored in a clean, dry environment, away
from direct heat sources between +10
and +30
C, at a humidity of less than 65%
o
RH.
NOTIFIED BODIES
BSI (0086)
Kitemark Court,
Davy Ave,
Knowlhill,
Milton Keynes,
MK5 8PP.
England
DISPOSAL
Disposal of the components must be
carried out in accordance with local
regulatory requirements.
WARRANTY
The
products
factories in Skelmersdale and Vaasa carry
a warranty of 12 months (unless stated
otherwise).
This includes parts, labour
and return to site The warranty period
runs from the date of purchase by the end
user.
These products are warranted to be free
from defects in materials and workmanship
at the time of delivery. Scott Safety will
be under no liability for any defect arising
from wilful damage, negligence, abnormal
working conditions, failure to follow the
original
manufacturer's
misuse or unauthorised alteration or
repair.
Evidence of purchase date will need to
be produced for any claims arising during
the warranty period. All warranty claims
must be directed through Scott Safety
customer services and in accordance with
our sales return procedure.
13
manufactured
at
instructions,
C
o
our
FH4

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis