Errors Appearance - Ilife V3s Pro Benutzerhandbuch

Trouble Shooting

2. Errors appearance

Errors
appearance
Circling in
place
Keep
moving back broken.
Bump the
The bumper is
obstacle
compressed
continuously
Short
working time capacity weakens.
"Cleaning"
light
is off when
charging
Vacuum dirt, Filter is dirty or wet by
debris less
Spit out litter The dust bin is full.
The robot
will not clean when you re-start the
automatically robot.
at scheduled The robot is powered
time.
13
Likely Cause
V3s Pro robot's side
wheel is stuck
A cliff sensor is dirty or
The battery storage
No charging fully.
Something like pet hair
filled in the socket of
the charger.
The robot's battery is
not connected
water.
The setting for Time
Scheduling isn't saved.
Time Scheduling
function is cancelled
OFF.
The robot's battery is low.
The robot's components
are tangled with debris.
Solution
Clean V3s Pro robot's side wheels of
hair and debris. Push them in and out
and confirm that they both turn freely.
Start V3s Pro robot in a new location.
Inspect and clean V3s Pro robot's cliff
sensors.
Briskly tap V3s Pro robot's bumper
10-20 times to dislodge any debris that
may be trapped under the bumper or
loosen the screw of the bumper.
Replace the battery.
Recharge the robot.
Clean the socket, check the
connection between charger and
battery.
Clean Filter or change the Filter
Empty the dust bin.
Reset Time Scheduling function,
remember the final confirmation
Power ON the robot.
Keep the robot powered ON and on
the Charging Dock to make sure it has
a full battery to work at any time.
Power OFF the robot, clean the Dust
Bin and invert the robot. Clean Side
Brushes and the Main Brush.
For more detailed information, please v1s1t: www.ilifcrobot.com