Product Maintaining; Cleaning Side Brushes; Cleaning Dust Bin And Filters - Ilife V3s Pro Benutzerhandbuch

Product Maintaining

1. Cleaning side brushes

Clean the side brushes when it gets dirty and replace if it's damaged.
Note: Before replacing side brushes, check and match "L" "R" mark on both side brush and bottom
of robot.
2. Cleaning dust bin and filter
Clean and empty dust bin after each use, steps are as shown in below figures.
Note:
After taking out dust bin, check whether there is foreign matter stuck in suck passage and clean it.
Clean Filter after 15-30 days' use. And replace it after use for 6 months at maximum.
Install both Filter and primary filters when they are dry.
Filter and primary filter could be replaced if needed.
:::: = ============='. :::: = ============:::::'. :::: = ============='.�------�
A
•
"l
... .... .
E
3. Cleaning cliff sensors and auto charging pins .
Slightly clean the sensor window and auto charging
pins with a soft dry cloth.
Note:
Charge connecting points on charging home base need to clean
'"'F-=-1-t-::ll--Charge Connecting Points
'/..iJ�.-6"
For more detailed information, please visit: www.limex.ch
B
F
-Charge Connecting Points
"--
""""'
C
G
. - .
l
D
10