Various Cd Playback Features; Listening To The Desired Sequence (Program Playback) - Kenwood HM-L700 Bedienungsanleitung

Various CD playback features

Listening to the desired sequence
Use the following procedure to program desired tracks in a desired order. (up to 32 tracks)
Operation is performed from the remote control unit.
Select the CD input. Carry out this operation while the unit is stopped.
1
Select "PGM" mode.
Press the P.MODE key.
2
Select track numbers in the order you want to play them.
1
Select the track.
2
(Go to step within 20 seconds.)
2
Confirm the selection.
(To select more than one track, repeat steps 1 and
2 for each track.)
3
Start playback.
28
EN
(program playback)
"PGM" lights
Program sequence number
Sequence for pressing numeric keys
To select track No. 12 : +10, 2
To select track No. 40 : +10, +10, +10, +10, 0
÷ Tracks can be selected using the 4 and ¢ keys.
÷ Up to 32 tracks can be programed. When "PGM FULL"
is displayed, no more tracks can be programed.
÷ When a track No. is entered, the track will be added to
the end of the existing program.
÷ When the total time of CD program is 1,000 minutes
or more, the time display shows " - - : - - ".
÷ If the wrong track No. is selected in step 1, press the
STOP key and reselect a track.
To edit the program after step 2, do so as explained in
"To clear a programed track".
÷ Tracks will be played in the order they were pro-
gramed (following the program numbers).
÷ When the 4 key is pressed once during playback,
the track being played will be played from the
begining.
To skip further to a track preceeding the current track,
press the 4 key twice repeatedly.
÷ When the ¢ key is pressed during playback, play will
skip to the next track in the program.
Various CD playback features
Selection of tracks
ª