Samson AirLine 88 Handbuch Seite 6

Quick Start
Turn on the power to the
transmitter by sliding the
Power switch to the left.
Press the SELECT button on the front of the CR88
receiver to choose an available channel. The channel
number will increase by one digit, from 0-9 then A-F.
Once the last channel has been reached, the count
will cycle back to 0.
Position the AG8 transmitter about 6"–12" (15cm–30cm) from the front of the
CR88 with the transmitter's IR Lens facing the IR transmitter on the front panel of
the CR88 receiver.
Press and hold the CR88 SELECT button to set the transmitter to the same channel
as the receiver via infrared transmission. The CR88 display will flash while the
receiver is sending the operating channel.
9. Press and hold SELECT button to IR set
Note: The AG8 will only accept infrared transmission from the receiver for
the first 10 seconds after the AG8 is powered on. If you need to change
the operating channel, the AG8 must be first powered off, then powered on
again to receive the new channel.
6
10. Adjust Volume control