Quick Start - Samson AirLine 88 Handbuch

Quick Start

In order for your wireless system to work correctly, both the receiver and transmitter must be set
to the same channel. Follow this basic procedure for setting up and using your AirLine 88
Guitar wireless system:
Physically place the CR88 receiver where it will be used, and extend the antennas
vertically. The general rule of thumb is to maintain "line of sight" between the
receiver and transmitter so that the person using the transmitter can see the receiver.
With the CR88 receiver powered off, connect the included power adapter. Turn the
CR88 on momentarily to confirm that the unit is receiving power. You'll see the LED
display light up. Then turn the CR88 power off.
With your amplifier or mixer off and volume control all the way down, connect the
CR88 receiver to the input of an amplifier or the mic or line level input of a mixer
using the balanced XLR output or unbalanced ¼"output. Turn the Level knob on the
CR88 completely counterclockwise, then turn its power on.
With the AG8 powered off, install a fresh AA battery.
Be sure to observe the plus and minus polarity markings.
AirLine 88 Guitar Wireless System
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
FREQ:
(2) this device must accept any
542-566MHz
interference received, including
interference that may cause
undesired operation.
5